AirTies WOB-201 Bedienungsanleitung PDF herunterladen (Seite 15)

AirTies WOB-201 User Manual

Configuring the WOB-201

This section describes how to configure your AirTies WOB-201 using the Web interface.

Connect your computer to the WOB-201 before you start configuring the software.

1) Connect your computer to the "LAN" port of the PoE power adapter using the Ethernet

cable.

2) Go to TCP/IP Properties and assign a local IP address to your computer within the

192.168.2.X IP address range (e.g. 192.168.2.5). Enter 255.255.255.0 as subnet mask.

2. Connect the other end of the Ethernet Surge Arrestor to the "LAN+DC" port of the

PoE power adapter.

3. You can connect the "LAN" port of the PoE power adapter to a switch or router.

Depending on how the WOB-201 will be used, the "LAN" port may or may not have

anything connected to it.

4. Connect the Power Adapter to a grounded AC outlet. It is recommended that easy

access be maintained at all times to the AC power socket.

NOTE: The power adapter and the AC socket must be in close proximity. A power

cord length of no more than 2 meters is recommended.

WARNING! This equipment must be grounded. Never defeat the ground conductor or

operate the equipment in the absence of a suitably installed ground conductor. Contact

the appropriate electrical inspection authority or an electrician if you are uncertain that

suitable grounding is available. Refer to national electrical codes or IEC 364, Parts 1

through 7.

5. Congratulations!!! You have successfully completed the hardware installation of the

WOB-201. Next chapter will explain how to do the software configuration.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Keine Kommentare

AirTies WOB-201 Bedienungsanleitung Seite 15